NETGEAR AC1200 JR6100 User Manual page 97

2. Click the Add button.
3. In the Route Name field, type a name for this static route (for identification purposes only.)
4. Select the Private check box if you want to limit access to the LAN only.
If Private is selected, the static route is not reported in RIP.
5. Select the Active check box.
6. Type the IP address of the final destination.
7. Type the IP subnet mask for this destination. If the destination is a single host, type
255.255.255.255.
8. Type the gateway IP address, which must be on the same LAN segment as the router.
9. Type a number from 1 through 15 as the metric value.
This value represents the number of routers between your network and the destination.
Usually, a setting of 2 or 3 works, but if this is a direct connection, set it to 1.
10. Click the Apply button.
The static route is added.

To edit or delete a static route:
1. Select ADVANCED > Advanced Setup > Static Routes.
The Static Routes screen displays.
2. In the table, select the radio button next to the route that you want to edit or delete.
3. Do one of the following:
• Click the Edit button.
The Static Routes screen adjusts.
a. Edit the route information.
b. Click the Apply button.
• Click the Delete button.
The route is removed from the table.
AC1200 WiFi Router JR6100
Advanced Settings
97