Bin Control Shutdown Delay - Hoshizaki FD-650MAH-C Instruction Manual

2. Bin Control Shutdown Delay

This is the delay between the infrared sensor detecting ice and the start of the shutdown
sequence. The infrared sensor shutdown delay is factory-adjusted to 100 seconds and
no adjustment is required for most dispenser unit/ice storage bin applications.
a) Standard Ice Storage Bin
When installed on a standard ice storage bin, any shutdown delay setting is acceptable.
b) Dispenser Unit
For typical dispenser unit applications, a 100-second shutdown delay is recommended.
However, on some dispenser unit applications, the ice level at shutoff may need to be
adjusted depending on the dispenser agitation or dispense method. Should a different
shutdown delay be desired, adjust S1 dip switch 1, 2, 3 to obtain the shutdown delay
needed. See the table below. For further details, contact Hoshizaki Technical Support at
1-800-233-1940.
Note: When the shutdown sequence begins, the compressor de-energizes immediately;
5 minutes later the gear motor and fan motor de-energize.
Increasing the shutdown delay allows a higher level of ice in the dispenser unit/
ice storage bin before shutdown. This could lead to icemaker movement or ice
overflow.
WARNING
S1 Dip Switch
NO. 1 NO. 2 NO. 3
OFF OFF OFF
ON OFF OFF
OFF ON OFF
OFF OFF ON
ON ON OFF
OFF ON ON
ON ON ON
Shutdown Delay
0 seconds
100 seconds (1.6 minutes)
1100 seconds (18.3 minutes)
1650 seconds (27.5 minutes)
2200 seconds (36.7 minutes)
0 seconds
0 seconds
30