Lincoln Navigator Owner's Manual page 296

Hide thumbs Also See for Navigator:

Table of Contents

Replacing the High-Mount Brake Lamp Bulbs

8. Install the lamp assembly with two screws.

Replacing Approach Lamp/Mirror Turn Signal Bulbs

For bulb replacement, see your authorized dealer.

2013 Navigator (nav)

Owners Guide gf, 1st Printing

To change the high-mount brake

1. Remove the two screws holding

the lamp assembly in place.

2. Pull the lamp assembly straight

3. Disconnect the wire harness.

4. Press the four tabs that hold the

light assembly on, one at a time,

and pull the black bulb carrier away

from the lamp.

5. Pull the old bulb out and replace

with the new bulb.

6. Snap the black bulb carrier into

the lamp assembly.

7. Connect the wire harness.

2013 navigator