Looking After The Drx-730; Resetting The Drx-730 - Yamaha PianoCraft DRX-730 Owner's Manual

Micro component system
Hide thumbs Also See for PianoCraft DRX-730:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1

Looking after the DRX-730

Installation
• Place the DRX-730 on a stable surface close to
your TV and the other AV components that you
intend to use with it.
• Do not place anything on top of the DRX-730.
• Do not place the DRX-730 on top of your TV.
And keep it away from components that are
sensitive to magnetism, such as video recorders.
• Do not place the DRX-730 on top of a power
amplifier or any other heat producing
component. If you install the DRX-730 in a rack,
place the amp or other heat producing
component on the bottom shelf to keep it as far
away as possible from the DRX-730.
Avoid locations that are...
• Subject to direct sunlight
• Very humid or poorly ventilated
• Subject to extreme temperatures
• Subject to vibration
• Very dusty
• Subject to smoke, steam, or hot temperatures,
such as a kitchen
Moving the DRX-730
Before you move the DRX-730, eject the disc if
loaded, close the disc tray, and press STANDBY/ON
to set it to standby. When the "STANDBY" message
has disappeared, disconnect the power cable from the
AC wall outlet.
Note:
• Disconnecting the power cable before the
"STANDBY" message has disappeared may reset
the DRX-730 to its factory defaults.
• Moving the DRX-730 with a disc inside may cause
damage.

Resetting the DRX-730

You can reset the DRX-730 to its factory defaults.
STANDBY/ON
TIMER
HDMI
PROGRESSIVE
STANDBY/ON
USB
PORTABLE
PHONES
1
Set the DRX-730 to standby.
2
While holding down Stop ( ) on the
DRX-730's front panel, press STANDBY/ON,
keeping Stop ( ) pressed until "DVD — NO
REQ." appears on the display.
3
Press Play/Pause ( / ) repeatedly to select
"DVD—INIT."
If you change your mind at this point, select
"DVD — NO REQ. " instead.
4
Press STANDBY/ON.
The DRX-730 is reset to its factory defaults and
goes on standby. Press STANDBY/ON again to
turn the DRX-730 back on.
The TV Screen, HDMI Resolution, and other
settings will be set to their factory defaults. The
HDMI Audio setting will be set to off.
Appendix
Play/Pause (
)
Stop (
)
VOLUME
INPUT
65
En

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents