GE JB940 Owner's Manual page 43

Roasting rack
Oven shelf
Offset shelf
Wire cover holder
Oven Heating Elements
Do not clean the bake element or the broil element.
Any soil will burn off when the elements are heated.
To clean the oven floor, gently lift the bake element.
Clean with warm soapy water.
Oven Shelves and Convection Roasting Rack
Clean the oven shelves (including the offset shelf) and
the convection roasting rack with an abrasive cleanser or
steel wool. After cleaning, rinse the shelves and rack
with clean water and dry with a clean cloth.
NOTE: The oven shelves and convection roasting rack may be
cleaned in the self-cleaning oven, however, the shelves will darken
in color, lose their luster and become hard to slide if cleaned during
the self-cleaning cycle. You can wipe the shelf supports with
cooking oil after self-cleaning to make the shelves slide more easily.
Oven Light Replacement
CAUTION: Before replacing your oven light bulb,
disconnect the electrical power to the range at
the main fuse or circuit breaker panel.
Be sure to let the light cover and bulb cool completely.
To remove the cover:
Hold a hand under the cover so it doesn't fall when
1
released. With fingers of the same hand, firmly push
back the wire cover holder. Lift off the cover.
Do not remove any screws to remove the cover.
Replace bulb with a 40-watt household appliance
2
bulb.
To replace the cover:
Place it into groove of the light receptacle. Pull wire
1
forward to the center of the cover until it snaps into
place.
Connect electrical power to the range.
2
43