GE JTP10GS Use And Care Manual page 18

How to Set the Oven for Cleaning
Quick Reminder:
Prepare the oven for cleaning.
1.
2. Close the oven door completely.
3. Slide the latch handle to the right as far as it
will go.
4. Press the CLEAN pad.
5. Press the INCREASE or DECREASE pad
until the desired Clean Time appears.
the oven is too hot and you start to set a clean cycle,
the word "OFF" will appear in the display. Allow
additional time for cooling before you try to
set the cycle.
Follow directions to prepare the oven for cleaning.
1.
2. Slide the latch handle to the
right as far as it will go.
Never force the latch
handle. Forcing the handle
will damage the door
lock
mechanism.
3. Press the CLEAN pad.
CLEAN
1 J
After a Clean Cycle
After cleaning is complete, the oven door will stay
locked until the oven cools. If you cannot slide the
latch easily to unlock the door, allow additional time
for cooling.
Never force the latch handle. The latch slides
easily. Forcing the latch handle may damage the
door lock.
(continued)
4. Press the INCREASE or DECREASE pad until the
desired Clean Time is displayed.
Clean Time is normally 3 hours. You can change the
Clean Time to anywhere between 2 and 4 hours,
depending on how dirty your oven is.
The self-clean cycle will automatically begin after
"CLEAN" is displayed and the time for the clean
cycle is set. The words "ON" and "LOCK" will
appear on the display. It will not be possible to open
the oven door until the temperature drops below the
lock temperature and the LOCK light goes off.
5. When the LOCK light is off, slide the latch handle
to the left as far as it will go and open the door.
The word "door" will be displayed, the word "LOCK"
will flash and oven control will signal if you set the
clean cycle and forget to close the oven door.
If "F-" and a number flash in display and the
control beeps, this indicates function error
code. If function error code appears during the
self-cleaning function, check the oven door
latch—the latch handle may have been moved,
even if only slightly, from the latched position.
Make sure the handle is to the right as far as it will
go. Press the CLEAWOFF pad. Allow the oven to
cool for 1 hour. If function error code repeats,
disconnect power to the range and call for service.
You may notice some white ash in the oven.
wipe it up with a damp cloth after the oven cools.
If white spots remain,
filled steel wool pad. Be sure to rinse thoroughly
with a vinegar and water mixture. These deposits
are usually a salt residue that cannot be removed
by the clean cycle.
If the oven is not clean after 1 clean cycle,
repeat the cycle.
NOTE: No functions can be programmed before
the door automatically unlocks.
Just
remove them with a soap-