Factory Default Settings - NETGEAR WN804 User Manual

Factory Default Settings

You can return the access point to its factory settings. Use the end of a paper clip or a similar
object to press and hold the Reset button on the back of the access point for at least 7
seconds. The access point resets and returns to the factory configuration settings shown in
the following table.
Feature
Access point User login URL
login
User name (case-sensitive)
Login password (case-sensitive)
Ethernet Ethernet MAC address
connection
Access point mode
Port speed
Local network LAN IP
(LAN)
Subnet mask
Gateway address
DHCP client
Time zone
Time zone automatically adjusts
for daylight savings time
Wireless Wireless communication
SSID name
Security
Broadcast SSID
Transmission speed
Country/region
RF channel
Operating mode
1. Maximum wireless signal rate derived from IEEE Standard 802.11 specifications. Actual throughput can vary.
Network conditions and environmental factors, including volume of network traffic, building materials and
construction, and network overhead, lower actual data throughput rate.
WN804 Access Point
Default behavior
http://192.168.0.233
admin
password
See the product label.
On
10/100 Mpbs
192.168.0.233
255.255.255.0
192.168.0.1
Disabled
Pacific time
Disabled
Enabled
See the product label.
WPA2-PSK (AES)
Enabled
1
Auto
Asia
Auto
Up to 270 Mbps at 2.4GHz
Supplemental Information
42