Table of Contents
Advertisement
NOTE: If there is no answer within 2 minutes after transferring the call,
then both units receive a call back notification. If neither unit answers
within 30 seconds, then the external call will be automatically dropped.
Push to Talk
This feature allows you to directly talk to another registered handsets or base by pressing
the PUSH TO TALK button on either handset or base respectively.
1. Make sure your phone is OFF (not in TALK mode).
. Press the PUSH TO TALK button on base or handset.
3. A list of registered handsets and base shows on the display.
4. Use the 5 or 6 button to desired handset or base. The default setting at base is
HANDSET 1 and the default setting at handset is BASE.
5. Press the SELECT (SKL) to save your selection.
6. Press and hold the PUSH TO TALK button to connect with the desired handset or base.
Intercom Operation
A two-way intercom is possible between the base and cordless handset(s) without
tying up the telephone line and since the telephone line is not used, you can still receive
incoming calls.
Making an Intercom Call
1. Make sure the phone is OFF (not in TALK mode).
. Press the int button.
3. Use the 5 or 6 buttons to select the desired handset or base.
NOTE: If you only have one handset registered in the system, it is
paged automatically.
4. Press the SELECT (SKL).
5. The receiving handset or base is paged, a tone is sounded and the following
information shows in the display:
Originating Handset/Base
PAGING
HANDSET 2
EXIT
PAGING FROM
HANDSET 1
OK
Receiving Handset/Base
EXIT
33
Advertisement
Table of Contents
