Emerson MONACO CF830GES00 Owner's Manual page 7

17. 10" Downrod Installation: Remove the grommet
from the coupling cover, then slide the coupling
cover on the downrod until it rests on the motor
housing. Be sure that the coupling cover is
oriented correctly (Figure 10).
18. Slide the decorative lower scroll onto the 10"
downrod, positioning the lower lip of the scroll
into the hole of the coupling cover (Figure 10).
19. Slide the decorative upper scroll onto the 10"
downrod, positioning the three interlocking tabs
of the decorative upper scroll into the interlocking
tabs of the decorative lower scroll (Figure 10).
20. Tighten the decorative upper scroll to the 10"
downrod using the supplied 2mm hex wrench
(Figure 10).
Figure 10
21. Position the ceiling cover over the downrod. Be
sure the cover is oriented correctly, with the large
opening at the top (Figure 11).
Figure 11
10" DOWNROD
DECORATIVE UPPER SCROLL
HEX SCREW
INTERLOCKING TABS
(3 ON EACH SCROLL)
DECORATIVE LOWER SCROLL
COUPLING COVER WITH
GROMMET REMOVED
10" DOWNROD
CEILING COVER
TIGHTEN HEX SCREW
7
22. Reinstall the hanger ball on the downrod
as follows. Route the motor leads through the
hanger ball and slide the hanger ball over the
downrod (Figure 12). Install the pin through the
holes at the top of the downrod and slide the
hanger ball up the downrod, aligning the ball so
the pin is captured in the groove in the top of the
hanger ball. Pull the hanger ball up tight against
the pin and securely tighten the setscrew in the
hanger ball. A loose setscrew could create fan
wobble.
23. The blue, black, white, and yellow leads exiting
the downrod are 80-inches long. Before installing
the fan, measure up approximately 6 to 9-inches
above the ball/downrod assembly. Cut off excess
leads and strip back insulation 1/2-inch from end
of leads.
PIN
SETSCREW
CEILING
COVER
Figure 12
WARNING
!
It is critical that the pin in the hanger ball is properly
installed and the setscrew securely tightened.
Failure to verify that the pin and setscrew are
properly installed could result in the fan falling.
24. Install four 40-watt candelabra base light bulbs
(supplied) in the uplight sockets (Figure 13).
UPLIGHT SOCKET (4)
40-WATT CANDELABRA
BASE LIGHT BULB (4)
Figure 13
25. You have now completed the initial assembly of
your new ceiling fan. You can now proceed with
hanging and wiring your fan.
HANGER BALL
DOWNROD
U.L. Model No.: CF830 U.L. Model No.: CF830