Belt Clip And Optional Headset; Connecting The Belt Clip; Changing The Battery - GE 28011 User Manual

IMPORTANT NOTE: When you want to use the handset
microphone to record ringer tones, DO NOT insert the Audio
cable or the optional headset into the headset jack of the
handset.
Choosing the Recorded Sound Clip as Ringer
Tone
Refer to Section; "Telephone Setup/Sound Setting/Ringer Tone".
Assigning the Recorded Sound Clip to Phone
Book Record
Refer to Section; "Phone Book/Adding Phone Book Entries and Phone
Book/Editing a Phone Book Record".

Belt Clip and Optional Headset

Connecting the Belt Clip

1. To attach the belt clip, insert the sides of the belt clip into the slots on
each side of the handset.
. Snap the ends of the belt clip into place.
Connecting an Optional Headset to the Handset
Each handset can be used with an optional headset for hands free
operation.
1. Connect the headset to the headset jack on the side of the handset.
The handset receiver and microphone are disabled when the
headset is connected.
. Adjust the headset to rest comfortably on top of your head and over
your ear. Move the microphone to approximately two to three inches
from your mouth.
3. Press the TALK/CALL BACK button to answer a call or make calls using the
headset.
4. To return to normal operation, unplug the headset from the jack.

Changing the Battery

CAUTION: To reduce the risk of fire or personal injury,
use only the Thomson Inc. approved model 5-2660
Nickel-metal Hydride battery (Ni-MH), which is
compatible with this unit.
1. Make sure the telephone is OFF (not in TALK mode) before you replace
the battery.
. Remove the battery compartment door.
3. Disconnect the cord attached to the battery pack and remove the
battery pack from the handset.
35