Installation Points To Remember; Before Beginning The Installation; After The Installation; Deciding On Component Locations - Clarion Ungo Pro Security RK1 Installation Manual

installation points to remember

before beginning the installation

I I M M P P O O R R T T A A N N T T ! ! This product is designed for fuel-injected, automatic transmission vehicles only. Installing it in a stan-
dard transmission vehicle is dangerous and is contrary to its intended use.
Please read this entire installation guide before beginning the installation. The installation of this
remote engine start system requires interfacing with many of the vehicle's systems. Many new
vehicles use low-voltage or multiplexed systems that can be damaged by low resistance testing
devices, such as test lights and logic probes (computer safe test lights). Test all circuits with a high
quality digital multi-meter before making connections.
Do not disconnect the battery if the vehicle has an anti-theft-coded radio. If equipped with an air
bag, avoid disconnecting the battery if possible. Many airbag systems will display a diagnostic
code through their warning lights after they lose power. Disconnecting the battery requires this
code to be erased, which can require a trip to the dealer.
Remove the domelight fuse. This prevents accidentally draining the battery.
Roll down a window to avoid being locked out of the car.

after the installation

Test all functions. The "Using Your System" section of the Owner's Guide is very helpful when testing.
Complete the vehicle Safety Check outlined in this manual prior to the vehicle reassembly.
Reinstall domelight fuse.

deciding on component locations

control module

Things to remember when positioning the control module:
Never place the control module in the engine compartment!
The first thing a thief will do when hot-wiring a vehicle is to remove the driver's side under-dash
panel to access the starter and ignition wires. You should therefore avoid placing the control
module just behind the driver's side dash to prevent it from being easily disconnected during a
theft attempt.
When locating the control module, try to find a secure location that will not require you to extend
the harness wires (they are 1.5 meters long).
4