Campbell CR10 PROM Replacement Procedure page 5

FIGURE 3. Separating the
Wiring Panel from the Control Module
FIGURE 4. Removing the End Cap
to Expose RF Shield
FIGURE 5. Removing the Circuit
Card from the Can
Copyright © 2002 Campbell Scientific, Inc.
815 W. 1800 N., Logan, UT 84321-1784 (435) 753-2342
CR10 PROM Replacement Procedure
6. Pull the control module forward to
separate it from the wiring panel
(Figure 3).
7. With a Phillips screwdriver, remove
from the control module the two
screws on the side opposite the con-
nectors (! on Figure 4).
"
8. Pull the end cap away from the con-
trol module and expose the RF shield
!
(" on Figure 4).
9. Lay the control module on a flat sur-
face (e.g., table) and push the RF
shield with your thumb while grasp-
ing the can to remove the circuit card
from the can (Figure 5).
3
App. Note: 1D-T