System Board - HP Z1 Specification

QuickSpecs
System Technical Specifications

System Board

System Board Form Factor Custom Motherboard, Custom Rear IO board, Custom Side IO board
Processor Socket
CPU Bus Speed
Chipset
Super I/O Controller
Memory Expansion Slots 4 DDR3 memory slots
Memory Type Supported
Memory Speed Supported Up to 1600MHz DDR3
Maximum Memory
PCI Express Connectors
Supported Drive
Interfaces
IEEE 1394 Connector(s)
USB Connector(s)
HD Integrated Audio
Flash ROM
CPU Fan Header
Single LGA 1155
DMI
Intel® PCH C206
Nuvoton NPCD379H
2GB, 4GB, and 8GB ECC Unbuffered DIMMs;
2GB non-ECC Unbuffered DIMMs
Mixing of ECC and non-ECC DIMMs is not supported.
32GB ECC or 8GB non-ECC
1 MXM slot (PCIe Gen2 x16, DP x 2)
3 miniPCIe slots (PCIe Gen2 x1, USB 2.0)
SATA
Integrated RAID
Integrated Graphics
Network Controller
Side
Side
Rear
Internal
Intel HD / IDT 92HD91 codec
Yes
Yes
DA - 14263 North America — Version 21 — October 4, 2013
Integrated Serial ATA interfaces (2x 6Gb/s SATA, 1x 3Gb/s
SATA).
NOTE: the Z1 supports a maximum of two SATA SFF/SSD drives
only. RAID 0 and 1 supported. (Factory integrated RAID is
Microsoft Windows only).
NOTE: Requires identical hard drives (speeds, capacity,
interface)
Integrated Intel HD Graphics 2000 (on Intel Core i3
processors).
Integrated Intel HD Graphics P3000 (on Intel Xeon E3-
12x5 processors).
Unified Memory Architecture (UMA)- A region of system
memory is reserved and dedicated to the graphics
display.
DirectX 10.0 compliant.
OpenGL 3.0 on Intel HD Graphics P3000)
Integrated graphics can support dual display across the
embedded DP to the LCD panel and the DP output on the
Rear IO.
Integrated Gbit LAN MAC by Intel PHY Lewisville 82579LM;
Management capabilities WOL, PXE 2.1 and AMT 7
1 IEEE 1394a
2 USB 3.0
4 USB 2.0
1 USB 2.0 Type A, 2 USB 2.0 on a 9-pin header
HP Z1 Workstation
Page 14