Leds; Product Label - NETGEAR ProSAFE FS526Tv2 Hardware Installation Manual

LEDs

The following table describes the LEDs.
Table 1. LED descriptions
Port
(Not applicable, system
LED)
Twenty-four 10/100BASE-T
ports (one LED for each
port)
Two Gigabits Ethernet ports
(one LED for each port)

Product Label

The product label on the back panel of the switch shows the hardware model number and
version, the software version, the unique MAC address, and the unique serial number. The
following figure shows a generic product label.
Figure 5. Generic product label
ProSAFE 26-Port Fast Ethernet Smart Switch FS526Tv2
LED Designation
Power •
•
Link/ACT •
•
•
Link/ACT •
•
•
Introduction and Hardware Description
Off. Power is disconnected.
Solid green. Power is supplied to the switch and the
switch is operating normally.
Off. No link is established on the port.
Solid green. A valid link (at any speed) is established on
the port.
Blinking green. Packet transmission or reception occurs
on the port.
Off. No link is established on the port.
Solid green. A valid link is established on the port.
Blinking green. Packet transmission or reception occurs
on the port.
9