Figure 55. Reset Response Table - IBM DJSA-210 - Travelstar 10 GB Hard Drive Specifications

Aborting Host interface
Aborting Device operation
Initialization of hardware
Internal diagnostic
Starting or Spinning Up spindle motor
Initialization of registers (*2)
DASP handshake
PDIAG handshake
Reverting programmed parameters to
default
!
Number of CHS (set by Initialize
Device Parameters)
!
Multiple mode
!
Write Cache
!
Delayed Write
!
Read look-ahead
!
ECC bytes
!
Volatile max. Address
!
Address offset mode
Power mode
Reset Standby timer value (*5)
o—execute
x—not execute
Note.
(*1). Execute after the data in write cache has been written.
(*2). The default value on POR is shown in Figure 55 on page 73.
(*3). The Set Features command with Feature register = CCh enables the device to revert these
parameters to the power on defaults.
(*4). In the case of sleep mode, the device goes to standby mode. In other cases, the device does not
change current mode.
(*5). After reset the Standby timer value is set to 109 minutes.
(*6). Set according to the initial power mode selection.

Figure 55. Reset response table

Travelstar 32GH/30GT/20GN hard disk drive specifications
hard
POR
reset
– o
– (*1)
o x
o x
(*6) x
o o
o o
o o
o o
(*6) (*4)
o o
72
soft
reset
o
(*1)
x
x
x
o
x
o
(*3)
(*4)
o