IBM DJSA-210 - Travelstar 10 GB Hard Drive Specifications page 200

R
Input Parameters From The Device
Sector Count
Sector NumberThis indicates the sector number of the last transferred sector. (L = 0)
Cylinder High/Low
H
13.40 Write Verify (3Ch: vendor specific)
In DJSA-XXX implementation, the Write Verify command is exactly the same as Write Sectors
command (30h). No read verification is performed after the write operation.
Refer to 13.39, "Write Sectors Command," on page 185 for parameters.
This indicates the retry bit. If the retry bit is set to one then retries are disabled.
When the write cache is enabled the retry bit is ignored. (Ignoring the retry bit is in
violation of ATA-3.)
This indicates the number of requested sectors not transferred. The Sector Count
will be zero unless an unrecoverable error occurs.
In LBA mode this register contains the current LBA bits 0–7. (L = 1)
This indicates the cylinder number of the last transferred sector. (L = 0)
In LBA mode this register contains the current LBA bits 8–15 (Low) and bits
16–23 (High). (L = 1)
This indicates the head number of the last transferred sector. (L = 0)
In LBA mode this register contains the current LBA bits 24–27. (L = 1)
Travelstar 32GH/30GT/20GN hard disk drive specifications
186