Device Control Register; Drive Address Register; Device/Head Register - IBM DARA-206000 - Travelstar 12 GB Hard Drive Specifications

9.6 Device Control Register

7
Figure 52. Device Control Register
Bit Definitions
SRST (RST) Software Reset. The device is held reset when R S T = 1 . Setting R S T = 0 re-enables
the device.
The host must set R S T = 1 and wait for at least 5 microseconds before setting
R S T = 0 , to ensure that the device recognizes the reset.
-IEN Interrupt Enable. When I E N = 0 , and the device is selected, device interrupts to the
host will be enabled. When I E N = 1 , or the device is not selected, device interrupts to
the host will be disabled.

9.7 Drive Address Register

7
H I Z
Figure 53. Drive Address Register
This register contains the inverted drive select and head select addresses of the currently selected drive.
Bit Definitions
HIZ High Impedance. This bit is not device and will always be in a high impedance state.
-WTG -Write Gate. This bit is 0 when writing to the disk device is in progress.
-H3,-H2,-H1,-H0 -Head Select. These four bits are the one's complement of the binary coded address
of the currently selected head. -H0 is the least significant.
-DS1 -Drive Select 1. Drive select bit for device 1, active low. D S 1 = 0 when device 1
(slave) is selected and active.
-DS0 -Drive Select 0. Drive select bit for device 0, active low. D S 0 = 0 when device 0
(master) is selected and active.

9.8 Device/Head Register

D e v i c e C o n t r o l R e g i s t e r
6 5 4
D r i v e A d d r e s s R e g i s t e r
6 5 4
W T G H 3 H 2
3 2 1 0
1 S R S T I E N 0
3 2 1 0
H 1 H 0 D S 1 D S 0
69
Registers