Table of Contents
Advertisement
IP Camera Installation
Loosen the locking screw on the zoom ring, adjust the zoom factor (from telephoto to wide angle)
b.
to achieve the desired field of view, then tighten the locking screw. If the focus is no longer sharp
after adjusting the zoom, repeat Step 7a to achieve a sharp image.
After you have adjusted the field of view, focal length, and zoom factor, install the black cover. Make
Step 12
sure to adjust the it so that it does not block the lens from capturing video.
Attach the dome cover to the conduit base by aligning it with the mounting holes.
Step 13
Use the included wrench and tighten the four dome cover screws to secure the dome cover to the camera.
Step 14
Make sure all parts of the camera are securely installed.
What to do next
After you install the IP camera, follow the instructions in the
Camera" section on page 3-1
Cisco Video Surveillance 3520 IP Camera Installation Guide
2-14
Zoom
Focus
to access the IP camera through your network.
Chapter 2
Camera Installation
"Performing the Initial Setup of the IP
OL-28645-01
Advertisement
Table of Contents
