Chapter 2
Camera Installation
Mounting the IP Camera Flush with a Surface
To mount the 3520 IP camera flush with a surface, complete the following steps:
Procedure
Step 1
Secure the IP camera inside the camera housing using the two included screws.
Remove the ceiling tile from the location at which you want to mount the IP dome and cut a 7-3/4 inch
Step 2
(19.68 cm) diameter hole in the center of the tile.
Place the camera housing through the hole that you cut in the ceiling tile.
Step 3
(Optional) Place a ceiling tile mount over the camera housing.
Step 4
Orient the ceiling tile mount so that it is flush with the back surface of the ceiling tile.
Use a Phillips-head screwdriver to turn the anchor screws clockwise and spin the anchor clips outward
Step 5
into the locking position and to secure the anchor clips.
OL-28645-01
Cisco Video Surveillance 3520 IP Camera Installation Guide
IP Camera Installation
2-7