Cisco 3520 Installation Manual page 22

IP Camera Installation
Loosen the locking screw on the zoom ring, adjust the zoom factor (from telephoto to wide angle)
b.
to achieve the desired field of view, then tighten the locking screw. If the focus is no longer sharp
after adjusting the zoom, repeat Step 7a to achieve a sharp image.
Install the black cover. Make sure to adjust the it inside the dome and trim ring assembly so that it does
Step 13
not block the lens from capturing video.
Attach the security strap from the dome and trim ring assembly to the camera housing using the included
Step 14
screw.
Attach the dome and trim ring assembly by positioning its pegs in the slots of the camera housing and
Step 15
twisting clockwise.
What to do next
After you install the IP camera, follow the instructions in the
Camera" section on page 3-1
Cisco Video Surveillance 3520 IP Camera Installation Guide
2-10
Zoom
Focus
to access the IP camera through your network.
Chapter 2 Camera Installation
"Performing the Initial Setup of the IP
OL-28645-01