Control Lock Pad; Locking The Cooktop; Lass Cooktop - GE ELECTRONIC TOUCH CONTROL PP950 Owner's Manual

Cleaningthe glass cooktop, ge.com
Control Lock Pad
As a convenience, you can lock the
entire cooktop at any time when it is
not in use or beti)re cleaning.
i,ocking the cooktop will prevent
surtace elements fl'om being turned
on accidentlv.
Begin by locking the cooktop; see
the
Locking the Cooktop
section. Use
the same cleaning methods as those
described for the glass-ceramic top.
Clean your cooktop after
each spill Use ceramic
cooktop cleaner.
Normal Daily Use Cleaning
ONLY use ceramic (ooktop cleaner on
the glass (ooktop. Other creams ma_ not
be as eflectixe.
To maintain and protect the surface of
yore" glass cooktop, tollow these steps:
[] Before using the cooktop for
the fi_t time, clean it with ceramic
cooktop cleane_: This helps protect
the top and makes cleanup easier:
[] Daily tlse of ceramic cooktop
cleaner will help kee I) the cooktop
looking new.
[] Shake the cleanim,_ cream well.
Apply a few drops of ceramic
cooktop cleaner directly to the
cooktop.
[] Use a paper towel or cleaning pad
fi)r ceramic cooktops to clean the
entire cooktop sm_i_ce,
[] Use a dry cloth or paper towel
to remove all cleaning residue,
No need to rinse,
NOTE: It is very important that you DO NOT
heat the cooktop until it has been cleaned
thoroughl>
ii i
Use a cleaning pad for ceramic
cooktops.
Burned-On Residue
WARNING: DAMAGE to your glass surface
may occur if you use scrub pads other than the
pad included with your cooktop.
[] Allow the cooktop to cool.
[] Spread a few drops of ceramic
cooktop cleaner on the entire
burned residue area.
[]
Using the included cleanim*
pad fin" ceramic cooktops, Hfl) the
residue area, ali , ))lxing, I)ressm'e
as needed.
[] If any residue remains repeat the
steps listed aboxe as needed.
[] For additional protection, after all
residue has been remoxed, polish
the entire surface with ceramic
cooktop cleaner and a paper towel.
The ceramic cooktop scraper
and all recommended suppfies are
available through our Parts Center.
See instructions under "To Order
Parts" section on next page.
NOTE:Do not use a dull or
nicked blade.
Heavy, Burned-On Residue
[] Allow the (ooktop to cool.
[] Use a single-edge razor blade
scraper at approximately a 45 °
angle against the glass surfitce
and scrape the soil, It will be
necessary to apply pressm'e to
the razor scraper in order to
remove the residue.
[]
After scraping with the razor
scrape*, spread a few drops of
(erami( (ooktop (leaner on the
entire bm'ned residue m'ea. Use the
[]
cleaning pad to remove any
remaining residue.
For additional protection,
after all residue has been
removed, polish the entire
surlhce with ceramic cooktop
cleaner and a paper towel.
13