Bridge Surface Element; Control Lock-Out; Dual Surface Element; Control Lock Knob - GE JCP910 Owner's Manual

Large
Small
surface
surface
element
element
setting
setting

Dual Surface Element

The right front surface element has 2 cooking
sizes to select from so you can match the size of
the element to the size of the cookware you are
using.
To use the large surface element, turn
the SELECTOR knob to
turn the control knob to the desired
setting. The element will heat the entire
area contained by the larger circle.

Bridge Surface Element

You can create an oblong heated area by using
the left rear element in addition to the front
element bridge combination.
Make sure the pan rests flat on the glass
cooktop.
When the SELECTOR knob points to
the control knob controls both the left
front surface element and the bridge
area.
Surface Elements Cycle On and Off
Surface elements will cycle on and off
to maintain the temperature you have
selected.
All radiant surface elements have a
temperature limiter that protects the
glass cooktop from getting too hot.

Control Lock-Out

To lock the cooktop and prevent
unwanted use, turn the control lock
knob to LOCK. An indicator light will
glow to show that the cooktop is locked.
(on some models)
To use the small surface element, turn
the SELECTOR knob to
turn the control knob to the desired
setting. The element will only heat
the area inside the smaller circle.
. Push in and
(on some models)
Choose pans that match the
circle/bridge area as closely as possible.
When the SELECTOR knob points to
the control knob controls the left front
surface element only.
,
The temperature limiter may cycle the
elements off while cooking if:
I
The pan boils dry.
I
The pan bottom is not flat.
I
The pan is off-center.
I
There is no pan on the element.
To unlock, press and turn the knob to
UNLOCK.
In the locked position, the cooktop will
produce an audible sound if any control
knob is set to a position other than OFF.
www.GEAppliances.ca
. Push in and
,
7