Final Checklists; Pre-Test Checklist; Operation Checklist - GE TRIVECTION JT930 Installation Instructions Manual

FINAL CHECKLISTS

PRE-TEST CHECKLIST

14
A Remove all protective film.
Check to be sure that all wiring is
B
secure and not pinched or in contact
with moving parts.
Check that the bottom trim is installed
C
properly (see Steps 11 and 12).
Check to be sure the mounting screws
D
are installed and flush with the side trim
(see Steps 9 and 10).
Installation Instructions
15

OPERATION CHECKLIST

15
A Remove all items from the inside of the
oven.
B Check that conduit is securely connected
to the junction box.
Turn on the power to the oven. (Refer
C
to your Owner's Manual.) Verify that the
bake and broil functions make the oven
hot. Verify by feeling heat coming off the
elements within 20 seconds.
See your Owner's Manual for
D
troubleshooting list.
NOTE TO ELECTRICIAN:
The power leads supplied with this appliance
are UL recognized for connections to larger
gauge household wiring. The insulation of
these leads is rated at temperatures much
higher than the temperature rating of
household wiring. The current carrying
capacity of a conductor is governed by the
wire gauge and also the temperature rating
of the insulation around the wire.
NOTE: ALUMINUM WIRING
WARNING:
A
CONNECTION OF ALUMINUM HOUSE
WIRING TO THE COPPER LEADS CAN
RESULT IN AN ELECTRICAL HAZARD
OR FIRE.
B Splice copper wires to aluminum wiring
using special connectors designed and
UL approved for joining copper to
aluminum, and follow the manufacturer's
recommended connector procedure
closely.
NOTE: Wire used, location and enclosure
of splices, etc., must conform to good
wiring practice and local codes.
IMPROPER