TP-Link JetStream TL-SG3424P User Manual page 152

The following entries are displayed on this screen:
Create Extend-IP ACL
ACL ID:
Rule ID:
Operation:
S-IP:
D-IP:
Mask:
IP Protocol:
TCP Flag：
S-Port:
D-Port:
DSCP:
IP ToS:
IP Pre:
Figure11-8 Create Extend-IP Rule
Select the desired Extend-IP ACL for configuration.
Enter the rule ID.
Select the operation for the switch to process packets which match
the rules.
Permit: Forward packets.
Deny: Discard Packets.
Enter the source IP address contained in the rule.
Enter the destination IP address contained in the rule.
Enter IP address mask. If it is set to 1, it must strictly match the
address.
Select IP protocol contained in the rule.
Configure TCP flag when TCP is selected from the pull-down list
of IP Protocol.
Configure TCP/IP source port contained in the rule when
TCP/UDP is selected from the pull-down list of IP Protocol.
Configure TCP/IP destination port contained in the rule when
TCP/UDP is selected from the pull-down list of IP Protocol.
Enter the DSCP information contained in the rule.
Enter the IP-ToS contained in the rule.
Enter the IP Precedence contained in the rule.
143