Advertisement
FLEXIDOME In-ceiling Housing for Plenums
10. Discard the wire clamp.
11. Re-install the Earth Ground, with the terminal oriented close to the housing body, with
12. Tighten the screw securely.
13. Finish wiring the camera as appropriate.
14. Pull the wire bundle and rubber strain relief tightly to and slightly up over the housing.
15. Feed this up into the In-ceiling Housing for Plenums, with the keyhole mounting slots
16. Rotate the housing in the In-ceiling Housing for Plenums until the third slot allows
17. Tighten all three (3) #10 screws.
18. Complete the installation following the instructions in the Installation Manual (included
Bosch Security Systems, Inc.
the screw.
over the two (2) pre-installed #10 screws.
insertion of the third #10 screw.
on the CD in the shipping box).
Installation Manual
Installing a FLEXIDOME In-ceiling Housing for Plenums | en
F.01U.276.976 | 1.4 | 2012.12
5
Advertisement
