Adjusting the harness
You should always use the harness with the machine to give
maximum control over the machine and reduce the risk of
fatigue in your arms and back.
•
Put on the harness.
•
Hook the machine onto the harness support hook.
•
Adjust the length of the harness so that the support hook
is roughly level with your right hip.
Filling with oil
•
Open the cap on top of the bar head
•
Fill with Husqvarna saw chain oil.
•
Refit the cap.
14 –
English
ASSEMBLY
Check before starting
•
Inspect the working area. Remove any objects that could
be thrown out.
•
Check the cutting attachment. Never use blunt, cracked or
damaged equipment.
•
Check that the machine is in perfect working order. Check
that all nuts and screws are tight.
•
Make sure the chain is adequately lubricated. See
instructions under the heading Lubricating the cutting
attachment.
•
Check that the cutting attachment always stops when the
engine is idling.
•
Only use the machine for the purpose it was intended for.
•
Make sure the handle and safety features are in order.
Never use a machine that has any parts missing or has
been modified in relation to the specification.