GE Dryers Owner's Manual page 13

REMOVE DOOR ASSEMBLY
2
(cont.)
Lay the door down on a soft protected flat
surface so that the inner part faces upward
(door resting on the handle side).
Remove the 6 large tapping screws
(#10) located around the perimeter of the
door outlining the gasket, the 4 machine
screws (#8).
2 #8 Machine
Screws
With the screws removed, turn the door over
and separate the silver cover part of the door
from the door frame and set aside.
3
IMPORTANT: Note the location of the hinge
(left or right) before removing.
With the door frame part of the door laid
down on a protected soft surface, remove
the hinge cover by removing the 2 tapping
screws (#8) that fasten it to the frame. The
hinge cover is located at the opposite side
of the hinge assembly.
6 #10 Large
Screws
Remove the window retainer and set it aside.
The window retainer is located on the side
opposite the hinge assembly and underneath
the plastic cover.
2 #8 Machine
Screws
Remove the hinge
assembly by removing
the 2 machine screws
(#8) that fasten it to the
frame. Pull the hinge
assembly out of its
cavity and set it aside.
13
REMOVE HINGE