Using Bosch Vms Configuration Wizard - Bosch DIP-3040-00N Installation Manual

DIVAR IP 3000
8.
9.
10. Click the Set time zone, Configure networking and Provide computer name and domain
11. Press CTR+ALT+DELETE. The Windows logon page is displayed.
12. Enter the password.
13. Double-click the Bosch VMS Wizard icon
14. Configure the system using the Configuration Wizard.
Notice!
If the IP addresses of devices that should be added fall within the same IP range as the DIVAR
IP, you can use the Configuration Wizard. In all other cases we recommend using the
Bosch VMS Configuration Client.
Notice!
To perform administrative tasks, the BVRAdmin account can be entered when Bosch VMS
default screen is displayed. To do so, press CTRL+ALT+DEL, then hold down SHIFT while
clicking the Switch User option.
See also:
–
–
–
4.4

Using Bosch VMS Configuration Wizard

Intended use for Configuration Wizard is the quick and easy configuration of a smaller system.
Configuration Wizard helps you to achieve a configured system including VRM, iSCSI system,
cameras, recording profiles and user groups.
User groups and their permissions are configured automatically. You can add or remove users
and set passwords.
Configuration Wizard can access Management Server only on the local computer.
You can save an activated configuration for backup purposes and import this configuration
later. You can change this imported configuration after import.
Configuration Wizard adds the local VRM automatically.
Restrictions:
The following tasks cannot be done with the Configuration Wizard. Use Bosch VMS
Configuration Client instead.
–
–
–
Bosch Sicherheitssysteme GmbH
After entering the password, a message is displayed that you must change the password
before logging on the first time. To confirm, click OK.
Change the password.
A series of scripts perform important setup tasks. This can take several minutes. Do not
turn off the computer.
A page is displayed where you can perform initial Windows configuration tasks.
Note: In case of password loss a system recovery must be performed as described in the
installation manual. The configuration must be done from scratch or must be imported.
link, enter the appropriate information, then click Close. Windows restarts.
The Bosch VMS default screen is displayed.
The Welcome page is displayed.
Using Bosch VMS Configuration Wizard, page 13
Using Bosch VMS Configuration Client, page 24
Recovering the unit, page 26
adding additional license packages
adjusting schedules
configuring systems with no or multiple VRM
to start the Configuration Wizard.
Installation Manual
System setup - first steps | en
2013.09 | V2 | DOC
13