Specifications - Pioneer CDJ-800 Operating Instructions Manual

OTHERS
TROUBLESHOOTING
Error Message Display
When the CDJ-800 CD player is unable to operate properly, an error code is displayed on the display panel. Check the error code displayed against the following table and take the
recommended action to correct the error. If an error code other than any of the error codes listed in the table below is displayed or if the same error code is displayed even after
corrective action has been taken, contact your nearest Pioneer Service Station or contact the store from which you purchased your player for assistance.
Error Code Error Type
E-72 01 TOC READ ERROR
E-83 01
PLAYER ERROR
E-83 02
E-83 03
E-91 01 MECHANICAL TIME OUT

SPECIFICATIONS

1. General
System ................................................................. Compact disc digital audio system
Power requirements ............................................................. AC 220-240 V, 50/60 Hz
Power consumption ............................................................................................ 21 W
Operating temperature ........................................................................ +5˚C – +35˚C
Operating humidity ..................................................................................... 5% – 85%
(There should be no condensation of moisture.)
Weight ................................................................................................................ 3.9 kg
Dimensions ..................................................... 305 (W) 331 (D) 108.5 (H) mm
2. Audio section
Frequency response .............................................................................. 4 Hz – 20 kHz
Signal-to-noise ratio ............................................................ 115 dB or more (JEITA)
Distortion ............................................................................................ 0.006% (JEITA)
32
<DRB1332>
En
Description
Player unable to read TOC data.
Disc is rotating, but rotation cannot be ascertained.
Player unable to play back currently inserted disc.
Mechanical operation has failed to complete within
specified time interval.
Possible cause and recommended action
Disc is cracked.
= Recommended action: replace disc.
Disc is soiled or dirty.
= Recommended action: clean disc.
If other discs play normally, the problem is with the disc itself.
Dust or some other form of foreign particles have found their way into
disc insertion slot.
= Recommended action: remove dust or other foreign particles.
3. Accessories
÷ Operating instructions ........................................................................................ 1
÷ Power cord ........................................................................................................... 1
÷ Audio cable .......................................................................................................... 1
÷ Control cord ........................................................................................................ 1
÷ Forced eject pin (housed in a groove in the bottom panel) ............................ 1
NOTE:
Specifications and design are subject to possible modification without notice.
Published by Pioneer Corporation.
Copyright © 2002 Pioneer Corporation.
All rights reserved.