Bosch MIC412 Installation And Operation Manual page 8

Dual optical / thermal ptz camera
Hide thumbs Also See for MIC412:
Table of Contents

Advertisement

MIC412TI and MIC412TF Camera | Installation and Operation Manual
MIC412 Camera Versions
This manual covers the installation & operation of the following MIC 412TI and
MIC 412TF Dual optical thermal PTZ cameras, briefly described below:-
MIC 412TI
The MIC 412TI is made from machined and cast aluminium and is
then pre-treated and painted with two part epoxy power coat paint in either RAL
9003 (Signal White)or RAL9005 (Jet Black), other colours are available on
request.. This unit incorporates a choice of 18x or 36x Day/Night optical camera
paired with a 50mm 9Hz Flir Thermal Imager.
MIC41 2TF
The MIC 412TF camera is made to the same specification as the
MIC412TI but fitted with a 25Hz Flir Thermal Imager, the 18x and 36x Day/Night
optical camera choices remain.
Bosch Security Systems
MIC 412 Power Supply Unit Versions and Options
CAUTION: Only use the specified power supplies with the
MIC 412.
Bosch Security Systems have designed a range of power supplies for the MIC412
cameras to cater for a variety of common voltages and provide all the connections
needed for power, telemetry and video. The power supply units and options are
detailed below. Refer to the MIC Series Power Supplies Installation Manual.
For MIC412 cameras only:-
MIC-240PSU-UL
MIC-115PSU-UL
MIC-24PSU-UL
DANGER:. ELECTRICAL SHOCK HAZARD
Ensure the power is disconnected prior to opening the power
supply enclosure. Power must be disconnected before
replacing any fuse in the MIC PSU.
The MIC power supplies have a separate internal shield
covering the power cable input header (HD1).
Only suitably qualified persons should remove this shield
and connect the mains power cable, the shield MUST be re-
fitted and fully secured prior to connecting the power.
The mains supply cable shall have conductors of a maximum
size of 12 AWG. A readily accessible disconnect device
(circuit breaker) shall be incorporated externally to the
equipment. The recommended rating is 15 A.
Issue 8
AAA
240VAC input Power Supply Unit
115VAC input Power Supply Unit
24 VAC input Power Supply Unit
EN | 8

Advertisement

Table of Contents
loading

This manual is also suitable for:

Mic412tfMic412ti

Table of Contents