Table of Contents
Advertisement
MIC412TI and MIC412TF Camera | Installation and Operation Manual
Other protocols use an add point method, where
Stop Recording
are used in the same way, but instead of manual control in the
middle
Add Tour Point
is used to insert a preset position with the options specified
Preset,
Dwell
and Speed.
Soft Stops and Non Dwell Zones
This feature offers a method of restricting the MIC's movements to a certain area.
A "box" is defined using the
Top Left
area within which the MIC is allowed to move. To clear the area set both corners to
the same location.
Non-Dwell Zone
This provides the opposite of Soft Stops, in that an area can be defined within
which the MIC cannot stop. The area is defined and cleared in the same way using
the
Top Left
and
Bottom Right
buttons. Once the MIC enters the area it passes
straight through to the opposite edge.
Clear
This button clears both the
Soft Stops
after a MIC has its protocol re-flashed (see Programming section).
Bosch Security Systems
Start Recording
and
and
Bottom Right
buttons which provides the
and the
Non-Dwell
Zone, which is required
MIC Setups
The
MIC Setups
tab contains the basic camera controls such as General Settings,
Multi alarms (if MIC-ALM card is fitted), Relays, AutoHome options and the Default
Settings.
Issue 8
AAA
EN | 28
Advertisement
Table of Contents
