Lower Cpu Dip Switch S1002 - Bosch LTC 8500 Instruction Manual

Lower CPU DIP Switch S1002

EN | 34
• Switch 5 of S1001
In the ON position, this switch is used to force the CPU into a "boot" mode so it
is ready to accept a download of an operating system program via its console
port. This setting should not be changed unless a problem has been encoun-
tered while attempting to download a new operating system program.
• Switch 6 of S1001
This switch selects the handshake setting of the console port when switch 5
(described above) is in the ON position. When ON, the handshake is enabled
(recommended position).
• Switch 7 and Switch 8 of S1001
These switches are used to set the baud rate when downloading a new operating
system program. It is recommended to use the fastest rate possible.
Switch Switch
7 8 Rate
OFF OFF 38400
OFF OFF 19200
ON OFF 9600
ON OFF OFF
The lower DIP switch provides several user-selectable options. These options are as
follows:
DIP Switch Factory Default
Number Setting
1 OFF
2 OFF
3 OFF
4 OFF
5 ON
6 OFF
7 ON
8 ON
• Switch 1 of S1002
This switch is not used in these systems and should be left OFF.
• Switch 2 of S1002
This switch allows the alarm port on the rear of the main Allegiant bay to con-
figure as an auxiliary console port when switch 2 is turned ON. This auxiliary
port allows the alarm port (in addition to the regular console port) to communi-
cate with the optional LTC 8059/00 MCS package or the optional LTC 8850/00
GUI Software package.
The port can also be used to control the Allegiant system via the Console Com-
mand Language (documented in the optional CCL manual). The normal con-
sole port and the alarm port (when switch 2 is ON) may be used to control the
Allegiant system simultaneously. Communications parameters (baud & hand-
shake) for the alarm port can be set using the keyboard (see User Function 32),
with the optional LTC 8059/00 MCS package or with the optional
LTC 8850/00 GUI Software package.
Baud
1200
S1002
"Lower"
Reserved
Alarm Port Mode
Old Keyboard Modes
Printer Port Mode
Security Feature
Not Used
Keyboard Protocol Mode
Communication Parameters
Bosch Security Systems | December 13, 2005
DIP Switch Function