Table of Contents
Advertisement
RAID Subsystem DVA-16K | Installation Manual
Power Socket
Fig. 6.11 Power Sockets and Power Switches
3.
Fig. 6.12 Removing the PSU Retention Screw
4.
Fig. 6.13 Pressing Down the PSU Handle
5.
Fig. 6.14 Dislodging the PSU
6.
CAUTION!
•
•
Bosch Security System
Power Switch
Remove the PSU retention screw at the top right-hand side of the PSU. (See Figure 6.12)
Remove the PSU module by pressing down the PSU handle found on the top of the PSU.
(See Figure 6.13) This will dislodge the PSU module from the subsystem.
PSU Handle
PSU Handle
After the PSU module has been dislodged from the enclosure, use the handle to gently
pull the PSU module out of the enclosure. (See Figure 6.14)
Remove the cooling module from the lower level of the PSU module. Please refer to
Section 6.6 Cooling Module Maintenance.
When a PSU is pulled out of the chassis, the cooling module beneath the PSU is removed
from the chassis at the same time.
It is recommended that the replacement procedure is completed in less than five (5) min-
utes to prevent the subsystem from overheating.
Power Socket
Power Switch
Subsystem Maintenance | en
F.01U.027.799 | V2 | 2008.08
51
Advertisement
Table of Contents
