Playback On A Tv Without; Audio And Video Inputs - GE CG709 User Manual

Playback on a TV without Audio/Video Input Jacks
To connect your camcorder to a TV without audio/video input jacks, follow
the steps below. You will need an optional 1CVA488 RF output adapter.
Optional accessories are shown on page 49.
VHF Antenna
1
OR
VHF
Optional 300/75 ohm
Transformer
(Such as 193983)
Installation
Disconnect the VHF antenna from
1
your TV and connect it to the
optional RF output adapter.
A.If your antenna is a round 75-ohm
cable, connect it to the ANT
connector on RF output adapter.
B.If your antenna is a flat twin-lead,
connect the flat-lead connectors to
the screw terminals on an optional
300-75 ohm transformer, such as
193983. Then connect the
transformer to the ANT connector
on the RF output adapter.
44
3 AUDIO, VIDEO, and RF OUT Jacks
(Located Behind Small Cover)
RF Output
Adapter
(Optional)
1
OR
3CH/4CH Switch
(Located on
Opposite side)
Optional 75/300 ohm
Transformer
(Such as AH011)
Attach the OUT connector of the RF
2
output adapter directly to the VHF IN
terminal on the back of your TV.
Note: If your TV has VHF screw
terminals, you may need an optional
75-300 ohm transformer, such as AH011.
Connect the three-pronged plug end
3
of the RF output adapter to the
AUDIO, RF, and VIDEO OUT jacks
on the camcorder.
Back of TV
(or VCR
Connected
to a TV)
2
VHF
OR
VHF