Date And Time Display; Recording The Time And Date (Or Date) On Your Tape; Install The Clock Battery - GE CG709 User Manual

Date and Time Display

Recording the Time and Date (or Date) on Your Tape

Install the clock battery and set the correct time and date before you record them
on your tape.
Whenever the time and date (or date) appear in the viewfinder, it will be recorded
on the tape. If you do not want to record the display, remove it from the
viewfinder by repeatedly pressing the DATE/TIME button.
Install Clock Battery
1. Remove the clock battery holder.
2. Insert the clock battery with the "+"
terminal facing down in the holder.
3. Fully insert the clock battery holder
into the camcorder.
Note: flashes in the viewfinder when
the clock battery is missing, discharged, or
not installed properly.
22
Press DATE/ To Display in Viewfinder
TIME Button and Record on Tape
One Time Date and Time
Two Times Date Only
Three Times Neither Date or Time
Four Times Returns to Date and Time
Clock Battery Holder
(Insert battery "+" side down.)
Cautions: Lithium cell battery. Must be disposed
of properly. Never handle a punctured or leaking
cell. May cause burns or personal injury.
Keep out of the hands of children. Can cause
death or injury if swallowed. If swallowed,
consult a physician immediately for emergency
treatment.
The lithium cell used in this device may explode
resulting in a fire or chemical burn if mistreated.
Do not recharge, disassemble, heat above 212˚F
(100˚C), or incinerate.
Never use metallic tweezers to hold the cell, and
never short circuit the + and – sides of the battery.