Table of Contents
Advertisement
Available languages
Available languages
HOW TO CONNECT ELECTRICITY
Do not, under any circumstances, cut or remove the third (ground) prong from the power cord.
For personal safety, this appliance must be properly grounded.
The power cord of this appliance is equipped
with a 3-prong (grounding) plug which mates
with a standard 3-prong (grounding) wall outlet
to minimize the possibility of electric shock
hazard from this appliance.
Have the wall outlet and circuit checked by a
qualified electrician to make sure the outlet is
properly grounded.
If you have only a standard 2-prong wall outlet,
it is your personal responsibility and obligation
to have it replaced with a properly grounded
3-prong wall outlet.
The wine chiller should always be plugged into
its own individual electrical outlet which has
a voltage rating that matches the rating plate.
USE OF ADAPTER PLUGS
Because of potential safety hazards under certain conditions, we strongly recommend against
the use of an adapter plug.
However, if you must use an adapter, where
local codes permit, a temporary connection may
be made to a properly grounded 2-prong wall
outlet by use of a UL-listed adapter available
at most local hardware stores.
The larger slot in the adapter must be aligned
with the larger slot in the wall outlet to provide
proper polarity in the connection of the
power cord.
When disconnecting the power cord from
the adapter, always hold the adapter in place
with one hand while pulling the power cord
plug with the other hand. If this is not done,
the adapter ground terminal is very likely
to break with repeated use.
READ AND FOLLOW THIS SAFETY INFORMATION CAREFULLY.
SAVE THESE INSTRUCTIONS
This provides the best performance and also
prevents overloading house wiring circuits which
could cause a fire hazard from overheated wires.
Never unplug your wine chiller by pulling on
the power cord. Always grip plug firmly and
pull straight out from the outlet.
Repair or replace immediately all power cords
that have become frayed or otherwise damaged.
Do not use a cord that shows cracks or abrasion
damage along its length or at either end.
When moving the wine chiller away from the
wall, be careful not to roll over or damage the
power cord.
(Adapter plugs not permitted in Canada)
If the adapter ground terminal breaks, DO NOT
USE the wine chiller until a proper ground has
been established.
Attaching the adapter ground terminal to a wall outlet
cover screw does not ground the appliance unless the
cover screw is metal, not insulated, and the wall outlet is
grounded through the house wiring. You should have the
circuit checked by a qualified electrician to make sure the
outlet is properly grounded.
www.GEAppliances.com
3
Hide quick links:
Advertisement
Chapters
Table of Contents
Troubleshooting
Need help?
Do you have a question about the Profile Wine Chiller and is the answer not in the manual?
Questions and answers
wine cooler does not kept right temp
The GE Profile Wine Chiller may not be maintaining the correct temperature due to one of the following reasons:
1. Door Not Closing Properly: Ensure the door is self-closing and fully closed. Check if a bottle or other obstruction is preventing the door from closing completely.
2. Improper Leveling: Verify that the wine chiller is firmly positioned with a 1/8-inch tilt to the back to aid door closure. Adjust the leveling legs by turning them clockwise to raise or counterclockwise to lower the unit.
3. Frequent Door Openings: Minimize door openings, as air carries moisture inside, which can affect the temperature.
If these steps do not resolve the issue, further diagnosis or professional servicing may be required.
This answer is automatically generated