Table of Contents
Advertisement
Icon
Item
Startup
[
]
Image
Power Save
[
]
QuickView
[
]
Digital
[
]
Zoom
Volume
[
]
System
[
]
Sound
Option
Functional Description
To set a startup image that is displayed every time
[
]
you power on the camera, follow the steps below.
If the camera is idle for a certain period of time
[
]
while the camera is powered on, it will switch to
power-saving state according to your settings. If the
[
]
camera is in power-saving state, re-activate it by
pressing any button.
[
]
[
]
camera will power off automatically.
Allows you to get a quick preview immediately after
[
]
an image is captured. The preview shows briefly and
then you may continue to capture the next image.
[
]
Allows you to activate or deactivate Digital Zoom
[
]
according to your preferences.
[
]
Allows you to adjust the volume of the video clips or
voice memos. You may set the volume level with the
[
Allows you to toggle system sound effects on or off,
[
]
such as the beep when pressing or scrolling.
[
]
1. Select [
], and then you will be prompted
to select a startup image. Use the
[
]/[
]/[
]/[
the image you prefer.
2. If you are not satisfied with the pre-installed
images, you may move to the bottom right
corner of the LCD monitor to customize your
startup image by selecting the images you like.
3. After the selection is done, press the OK button
to confirm, and then press the [
–
Off/30 sec./1 min./3 min.
If the camera is idle for 5 minutes, the
–
On/Off
–
On/Off
]/[
] buttons.
Using the Camera
] buttons to select
] to exit.
21
Advertisement
Table of Contents
