Mounting The Indoor Unit - Daewoo DSB-181LH Owner's Manual

MOUNTING THE INDOOR UNIT

The Indoor unit must be mounted before connecting the indoor/outdoor wire, drain hose and copper tubing. To mount,
follow the procedures below:
1. The tubing can be extended in 4 directions as shown
below. No cutting is necessary for left/rear and
right/rear tubing connections. If using left or right tub-
ing connections, remove the plastic area with a hack-
saw so pipes can go through.
Left/Rear
Left
Tubing
Tubing
3. Shape the tubing so it can easily go through the hole
in the wall. Push the indoor/outdoor wire, copper tub-
ing and drain hose through the hole in the wall angling
downward. Situate the indoor unit on the wall bracket
by lifting the indoor unit slightly above the wall bracket
and then down so it is securely locked in place.
PREPARING THE COPPER TUBING (NOT INCLUDED)
A copper tubing extension (not included) may need to be cut. If this is the case, it will also have to be deburred and
flared as shown below:
1. Cut the copper tube extension to the desired length
with a tube cutter. It is highly recommended that 1 foot
is added to the requested length. After cutting, debur-
ring may be necessary (see below diagram). Perform
this with a tube reamer.
BEFORE
CAUTION:
• When using the tube reamer, hold the tube downward and make sure no copper scraps fall into the tubing.
2. Make sure the drain hose and copper tubing are
Right/Rear
• Make sure the Indoor unit's AC cord is not connect-
Tubing
Right
• Be sure to comply with local codes on running a wire
Tubing
• DO NOT LET THE INDOOR/OUTDOOR WIRE
2. Make a flare at the end of the copper tube with a flare
AFTER
8
wrapped with the rubber insulation. Using the tape,
wrap the indoor/outdoor wire, copper tubing and drain
hose together.
CAUTION:
ed to AC power when performing these procedures.
from the indoor to the outdoor unit.
COME IN DIRECT CONTACT WITH THE TUBING
OR HOSE!
Wall Bracket
tool.
Make sure the inside surface and edges are smooth
and the sides are uniform length.
Flare nut
Connection
pipe
Flare tool
Insert Putty
Drain Hose