Power Amplifier Section; Preamplifier Section - Bryston B100 Owner's Manual

B100 SPECIFICATIONS:

POWER AMPLIFIER SECTION:

Power Output: 100 watts per channel into 8Ω
180 watts per channel into 4Ω
Input Impedance:
10K ohms single ended
Sensitivity: 1v = 100 Watts into 8 ohms
Distortion: THD+noise: < 0.005% 20Hz to 20kHz at 100
watts into 8 ohms,
IMD: < 0.010% 60Hz + 7KHz mixed 4:1
Noise: >108dB below rated output (with 20Hz to
22KHz bandpass filter)
Slew Rate: >60 volts per microsecond
Power Bandwidth: <1 Hz to over 100 kHz
Damping Factor:
Over 500 at 20 Hz, ref. 8 ohms
Power consumption: idle 30va, maximum power 600va
Heat load:
idle 100 btu/hr., max power 288 btu/hr
VARIOUS SPEAKER WIRE TERMINATIONS
B100 B100 B100
TWO CHANNEL POWER AMPLIFIER TWO CHANNEL POWER AMPLIFIER

PREAMPLIFIER SECTION:

Frequency response:
IMD or THD:
High Level Sensitivity:
Noise:
GENERAL:
Dimensions:
Weight:
AMPLIFIER OUTPUT BINDING POSTS
5
20Hz to 20KHz, ±.05dB
<.007%
500mV
100dB @ 20Hz to 20KHz
(ref: 1V input)
17" or 19"w x 4.75"h x 16"c
43.2 or 48.3mm wide x 12.1mm high x
40.6mm deep
approx. 30 lbs (13.6kg.)