Bryston B100 Owner's Manual page 5

BALANCE
REMOTE POWER CONTROL ~ 12 VOLT TRIGGER CONNECTOR:
Two trigger outputs are provided. A 12Vdc signal is placed across the T1 and C pins of the
connector whenever the unit is fully powered up. Then the unit goes into standby this voltage is removed.
that C means "common" here and both C C means "common" here and both
either absent or unacceptable.
When the left/right signal balance is being shifted one of these LEDs will light to indicate
which channel is being attenuated. Balance can be adjusted in 1dB increments to up
to -6dB in either direction. Stepping past -6dB in either direction will mute that channel
fully and the LED for that channel will turn red.
C C pins are electrically connected and identical. C pins are electrically connected and identical.
PROGRAMMING the "T2" 12v TRIGGER OUTPUT:
By default the T2 triggered output is inactive. To program this output to become active , T2 triggered output is inactive. To program this output to become active , T2
whereupon a control voltage of 12Vdc will appear across T2 &
specific source is selected, use the handheld remote control as follows:
select the source that you want to coincide with T2 going active.
•
While pointing the remote control at the B100, press the CODE button, followed by
•
the three digit code "247" using the keys numbered 1 through 0 in the illustration
at the left. On your remote control these keys, or buttons, are labeled AUX/PH (2),
ANALOG TUNER (4), DIGITAL CD (7).
• The three digit code should be entered within a few seconds of pressing CODE but-
ton or the unit will automatically return to normal operation.
• To clear the T2 trigger output, press the T2 trigger output, press the T2
"248": AUX/PH (2), AUX/PH AUX/PH (2),
HAND-HELD INFRA-RED REMOTE CONTROL:
The Bryston model B100 comes standard with a full function hand-held remote control unit.
The hand held remote unit is powered by two "AAA" batteries. To change the battery remove
the bottom cover plate by removing the four Philips screws on the rear of the remote unit.
Ensure that the batteries are correctly oriented and properly seated in the battery holder.
The B100 remote is a full function remote. It allows selection of all sources, volume up or
down (the volume control is a motor-driven design), mute ,left/right balance, power on/off
and discrete code entry.
We recommend maintaining a direct line-of-sight between the hand held remote unit and the
front of the B100 to ensure the most efficient operation of the remote features.
CODE button followed by the 3 digit code
ANALOG TUNER (4), ANALOG TUNER ANALOG TUNER (4),
3
B100
TWO TWO CHANNEL POWER AMPLIFIER TWO CHANNEL POWER AMPLIFIER
C C pins of the
A 12Vdc signal will be
placed across the other
pair of 12V TRIGGER
output pins (T2) when-
ever
programmed input is
selected as the source
input (see below for pro-
gramming instructions).
When any other input
source is selected the
12Vdc control voltage
will be removed from
these pins. Please note
T2 & T2 C C terminals whenever a C terminals whenever a
T2 going active. T2
DIGITAL TUNER (8). DIGITAL TUNER DIGITAL TUNER (8).
12V TRIGGERS
a certain user
CODE CODE but-