Fm Stereo/Mono; Save A Station Preset - B&K AVP4090 Owner's Manual

FM Stereo/Mono-

FM stereo is automatically selected when tuning a station. If you choose
to manually set it, press MENU until the display shows:
Now press x to change mode. You can toggle from stereo to mono by
repeatedly pressing the x button.

Save a station preset -

To save a station preset, tune the AVP to the desired station you wish to
save. You may use either method listed prior.
Press the SAVE button followed by the STA+ (or STA-) button until the
display shows the preset number where you want to save this frequency
at. The station preset number is the two digits at the right hand side of the
display. When saving, the AVP will still show the current frequency saved
in each particular preset that you are about to overwrite. The new
frequency will not be accepted until ENTER is pressed.
Press ENTER to save at desired preset number.
Example: Display shows frequency to save:
Press the SAVE button, the display reads:
Press the STA+ button, the display reads:
Now look at the two right most digits. They tell the station preset number
to save your selection under. Continue pressing the STA+ (or STA-)
button until the desired number is displayed (01-20).
Press the ENTER button to select the station preset number and save
 (
  '$.' 

 &%.# 
Page 30
Ignore 01 digits right now.