Mono Usage - B&K AV100.2 User Manual

Power and Amp Status LED
The "Power" LED on the back of the AV amplifier shows whether or not the
unit has power. If the LED is not lit, please check AC power connections, the
Main AC fuse and the Power Switch.
The "Amp" LED on the back of the AV amplifier shows the state of the unit.
The status LED shows the following:
Normal - When the unit is in normal use, the blue Power LED would be on
and the Amp Status LED would be green.
Standby - When the unit is in standby the Amp Status LED is off. The unit
would still have hard power, so the blue Power LED would still be on.
Limit - When the unit is under conditions of having too much of a signal, the
Amp Status LED will turn red. The audio from the amplifier may also clip,
distort, etc.
Temp - When the unit is being overheated the Amp Status LED would be yel-
low. Please check ventilation of the amplifier.

Mono Usage

The AV amplifiers have the ability to output a signal from both amplifier chan-
nels with only one input. Either the left or right input can be used and the sig-
nal would be sent simultaneously from the left and right amplifier channels.
Set the MONO DIP switch to the ON position. Shown below is the AV Ampli-
fier connected using the right input but either input can be used.
To Speakers
9
From preamplifier