Table of Contents
Advertisement
During the POST (Power-On Self-Test) routines, which are performed each time
the system is powered on, errors may occur.
Non-fatal errors are those which, in most cases, allow the system to continue the
boot-up process. The error messages normally appear on the screen.
Fatal errors are those which will not allow the system to continue the boot-up
procedure. If a fatal error occurs, you should consult with your system manufacturer
for possible repairs.
These fatal errors are usually communicated through a series of audible beeps. The
numbers on the fatal error list (on the following page) correspond to the number
of beeps for the corresponding error. All errors listed, with the exception of Beep
Code 8, are fatal errors.
A-1 AMIBIOS Error Beep Codes
Beep Code
1 beep
5 shorts, 1 long beep
1 long, 8 short
Appendix A
BIOS Error Beep Codes
Error Message
Description
Refresh
Circuits have been reset (Ready to power up)
Memory error
No memory detected in system
Video error
Video adapter disabled or missing
Appendix A: BIOS Error Beep Codes
A-1
Advertisement
Table of Contents
