H8DCL-6/i(F) SERVERBOARD USER'S MANUAL
Compact Flash Master/Slave Select
A Compact Flash Master (Primary)/
Slave (Secondary) Select Jumper is
located at JCF1. Close this jumper to
enable Compact Flash Card. For the
Compact Flash Card or the Compact
Flash Jumper (JCF1) to work properly,
you will need to connect the Compact
Flash Card power cable to JWF1 fi rst.
Refer to the board layout below for
the location.
I2C to PCI-Express Slot
2
2
JI
C1/JI
C2 allows you to enable the
2
I
C bus to communicate with the PCI-
Express slot. For the jumpers to work
properly, please set both jumpers to
the same setting. If enabled, both
jumpers must be enabled. If disabled,
both jumpers must be disabled. See
the table on the right for jumper
settings.
VGA Enable/Disable
JPG1 allows you to enable or disable
the VGA port. The default position is on
pins 1 and 2 to enable VGA. See the
table on the right for jumper settings.
LAN1/2 Enable/Disable
Change the setting of jumper JPL1/
JPL2 to enable or disable the LAN1/
LAN2 Ethernet ports. See the table
on the right for jumper settings. The
default setting is enabled.
Compact Flash Card Master/
Slave Select (JCF1)
Jumper Setting
Open
Closed
I
2
C to PCI-Express Slot
Jumper Settings
(JI
Jumper Setting Defi nition
Closed
Open
VGA Enable/Disable
Jumper Settings (JPG1)
Jumper Setting
Pins 1-2
Pins 2-3
LAN1/2 En/Disable Jumper
Settings (JPL1/JPL2)
Jumper Setting
Pins 1-2
Pins 2-3
2-18
Defi nition
Slave (Secondary)
Master (Primary)
2
2
C1/JI
C2)
Enabled
Disabled
Defi nition
Enabled
Disabled
Defi nition
Enabled
Disabled