Assembly - Healthrider R60 Treadmill User Manual

ASSEMBLY

Assembly requires two people. Place the treadmill in a cleared area and remove all packing materials. Do not
dispose of the packing materials until the treadmill is assembled.
Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a
small amount of lubricant may be transferred to the top of the walking belt, the sides of the walking platform, or
the shipping carton. This does not affect treadmill performance. If there is lubricant on top of the walking belt or
on the sides of the walking platform, wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.
Assembly requires your own phillips screwdriver
cutters .
1. Cut the plastic ties (not shown) off the sides of the tread-
mill. With the help of a second person, carefully raise
the Uprights (65) until the Wheels (not shown) are resting
on the floor.
Hold the Book Plate (114) against the back of the
Console Base (117) and the Upright (65), with the "V"-
shaped part of the Book Plate in the positioned shown.
Attach the Book Plate with four 3/4" Screws (40).
2. Insert one of the Handrail Extensions (76) into the post on
the left side of the Upright (65). Make sure that the
notch in the Handrail Extension is in the position
shown. Align the holes in the Handrail Extension with the
holes in the post. If necessary, use a rubber mallet to fully
insert the Handrail Extension. Attach the Handrail
Extension to the post with four Extension Screws (2).
Identify the Left Foam Grip (62), which has a hole in the
right side. Slide the Left Foam Grip as far as possible
onto the Handrail Extension (76) and the post. (Note: It
may be helpful to apply soapy water to the Handrail
Extension.) Press two Plastic Fasteners (75) into the bot-
tom of the Left Foam Grip and the Handrail Extension.
Attach the other Handrail Extension and the Right Foam
Grip (not shown) to the post on the right side of the Upright
(65) in the same way. Note: There is not a hole in the side
of the Right Foam Grip.
Identify the Left Cup Holder (126); the lower edge is nar-
rower on the left side, as shown. Press the Left Cup Holder
into the Book Plate (114). Next, press the Right Cup Holder
(not shown) into the Book Plate.
, rubber mallet
1
65
2
62
Hole
75
6
, and wire
"V"
114
40 40
117
40
114
126
65
Post
2
76
2
Notch
2