Healthrider R60 Treadmill User Manual page 7

3. With the help of a second person, raise the Frame (55) to
the position shown. Hold the Latch Housing (68) and the
Latch Housing Cover (5) against the sides of the Frame in
the indicated location. Loosely thread the two 1/2" Screws
(105) into the Latch Housing Cover and the Latch Housing
as shown. Do not tighten the Screws yet.
Remove the Latch Knob (67) from the Latch Pin (72).
Make sure that the Latch Pin Collars (70) and the Spring
(69) are on the Latch Pin. The Latch Pin Collars should be
on each side of the Spring. Insert the Latch Pin into the
Latch Housing (68), and tighten the Latch Knob onto it.
Align the Latch Pin (72) with the hole in the Left Foam
Grip (62) by sliding the Latch Housing (68) up or down.
Make sure that the Latch Pin can be inserted fully into the
hole. Hold the Latch Housing in place as you tighten two
3/4" Screws (40) in the Latch Housing and the Frame (55).
Tighten the 1/2" Screws (105). Note: It may be necessary
to pull the Latch Knob (67) to reach the Screws.
4. Make sure that all parts are properly tightened before you use the treadmill. Place a mat beneath the
treadmill to protect the floor or carpet. For your benefit, we recommend that you familiarize yourself with
the TROUBLESHOOTING section on pages 26 and 27.
3
62
69 70
70
40
7
Hole
5
68
Small
40
Holes
55
40
72
105
67
105