Healthrider R60 Treadmill User Manual page 27

PROBLEM
4. The walking belt is
off-center or slips
when walked on
5. The displays of the
console do not func-
tion properly
SOLUTION
a. If the walking belt is off-center, first re-
move the key and UNPLUG THE POWER
CORD. If the walking belt has shifted to
the left, use the allen wrench to turn the
left rear roller bolt clockwise 1/2 of a turn; if
the walking belt has shifted to the right,
turn the bolt counterclockwise 1/2 of a turn.
Be careful not to overtighten the walking
belt. Plug in the power cord, insert the key
and run the treadmill for a few minutes.
Repeat until the walking belt is centered.
b. If the walking belt slips when walked on,
first remove the key and UNPLUG THE
POWER CORD. Using the allen wrench,
turn both rear roller bolts clockwise 1/4 of a
turn. When the walking belt is correctly
tightened, you should be able to lift each
side of the walking belt 7-10cm (3-4 in.) off
the walking platform. Be careful to keep
the walking belt centered. Plug in the
power cord, insert the key, and walk on the
treadmill for a few minutes. Repeat until the walking belt is properly tightened.
a. Remove the key from the console and UN-
PLUG THE POWER CORD. Next, remove
the screws from the hood and carefully re-
move the hood. Locate the Reed Switch
(17) and the Magnet (12) on the left side of
the Pulley (11). Turn the Pulley until the
Magnet is aligned with the Reed Switch.
Make sure that the gap between the
Magnet and the Reed Switch is about
3mm (1/8 in.) If necessary, loosen the indi-
cated Screw (44) and move the Reed Switch slightly. Retighten the Screw. Re-at-
tach the hood and run the treadmill for a few minutes to check for a correct speed
reading.
27
a
b
a
3mm
44
12
17
Top
View
11