Assembly - Healthrider H50 Crosswalk Sl Treadmill User Manual

ASSEMBLY

• T o hire a service technician to assemble this
product in your home, call 1-800-445-2480.
• Assembly requires two persons.
• Place all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
materials until you finish all assembly steps.
• After shipping, there may be an oily substance
on the exterior of the treadmill. This is normal. If
there is an oily substance on the treadmill, wipe
it off with a soft cloth and a mild, non-abrasive
cleaner.
1. Make sure that the power cord is unplugged.
Remove and discard the two screws (A) and the
shipping bracket (B) from the right side of the
Base (74).
Remove and discard the screws and ship-
ping bracket (not shown) from the left side of
the Base.
2. Locate the Upright Wire (63) bundled around
the Base (74). Cut the plastic tie securing the
Upright Wire. Pull the end of the Upright Wire out
of the indicated hole.
See the inset drawing. Cut the plastic tie near
the Upright Wire (63). Be careful not to dam-
age the Upright Wire.
Press a Base Cap (70) into each side of the
Base (74).
• Left parts are marked "L" or "Left" and right parts
are marked "R" or "Right."
• To identify small parts, see page 6.
• Assembly requires the following tools:
the included hex keys
one Phillips screwdriver
scissors
To avoid damaging parts, do not use power tools.
1
2
Hole
7
B
74
74
Cut
Tie
63
Cut
63
70
A