Healthrider H400 Treadmill User Manual page 8

5. See the inset drawing. Make sure that there are two U-
nuts (112) in the upper end of each Upright (96). Note:
Extra U-nuts may be included.
Identify the right and left Handrails (108) (there is an
identification sticker on each Handrail). Hold the right
Handrail near the right Upright (96), and insert the Wire
Harness (118) into the large hole in the right Handrail
and out of the upper end as shown.
Next, hold the right Handrail (108) against the right
Upright (96). Tighten a 5/16" x 3 1/2" Bolt (121), with a
5/16" Washer (130), three to four turns into the right
Upright and the lower end of the right Handrail. Then,
tighten two 5/16" x 1" Bolts (113) into the upper end of
the right Handrail and the right Upright. Be careful not
to drop the Bolts into the Handrail. If necessary, raise
or lower the Handrail to thread the 5/16" x 1" Bolts into
the Upright. Firmly tighten all three Bolts.
Attach the left Handrail (108) to the left Upright (96) as
described above. Note: There is not a wire harness in the
left Upright.
6. See the inset drawing. Turn the Console (101) upside-
down on a soft surface. Remove the packing bands and
the Console Back (104).
If there are two Pulse Bar Screws (76) in each end of the
Console Frame (80), remove them. Hold the ends of the
Pulse Bar (77) against the Console Frame and attach the
Pulse Bar with the four Pulse Bar Screws. Firmly tighten
the Pulse Bar Screws. Be careful not to damage any
wires.
Locate the pulse wire extending from the Pulse Bar (77).
Insert the pulse wire under the Console Frame (80) and
plug the pulse wire into the indicated connector. The
pulse wire should slide easily into the connector and
snap into place; if it does not, turn the pulse wire and
then plug it in.
Attach the indicated ground wires to the Console Frame
(80) with a 1/2" Ground Screw (52).
7. Attach the Console Back (104) to the console assembly
with five 3/4" Screws (33). Be careful not to damage
any wires.
5
113
Left
96
108
130
121
6
76
52
Ground
Wires
Connector
7
Console Assembly
33
8
119
112
118
113
108
96
Right
130
121
77
101
80
Pulse
Wire
104
101
33
104
33