GE 10 AZA Owner's Manual page 19

3
Remove the Air Conditioner From the Case.
Remove the front grille. See the Care and
A
Cleaning section.
Find the locking plate located on the front
B
left side.
Remove the screw and the locking plate to
C
unlock the air conditioner.
Locking
plate
Remove
screw
Remove and discard the shipping screw on
D
the back of the air conditioner to allow
removal of the air conditioner from the case.
Remove
screw
Pull the bottom corners of the air
E
conditioner and slide it out of the case.
Remove the rear grille that is taped to the
F
back of the case. Remove the packet of screws
taped to the back of the grille. While holding
the grille at a 45° angle, insert it into the clips
at the top of the case and push the bottom in.
Keep slight upward pressure on the grille
until it fits flush with the bottom of the case.
If attaching the grille from the outside of the
case use the 2 long screws.
Insert the 2 long screws on the outside
If attaching the grille on the inside of the case use
the 2 short screws.
Insert the 2 short screws on the inside
Clips
19